ECITB Small Bore Tubing

Who is the course for?
This course is aimed at individuals who are preparing to take the ECITB Small Bore Tubing knowledge test.

Is previous experience required?
No prior experience is needed to complete this course. 

How will the course benefit me?
Incorrectly assembled small bore tubing components are the second-largest single source of hydrocarbon releases. This course will help you understand how to work with small bore tubing assemblies in their entirety; from P&IDs to tubing and support systems. It will identify potential problems with small bore tubing assemblies and enable you to mitigate these problems by following the correct procedures.

How will the course benefit my company?

Incorrectly assembled small bore tubing components are the second-largest single source of hydrocarbon releases. This course will help you understand how to work with small bore tubing assemblies in their entirety; from P&IDs to tubing and support systems. It will identify potential problems with small bore tubing assemblies and enable you to mitigate these problems by following the correct procedures.

What standards are referenced in the course?

This course is aligned with the knowledge sections of The Engineering Construction Industry Training Board (ECITB) SBT Training Standards:

• TSBT01: Assemble and Install: Focuses on the safe installation of twin ferrule fittings, tube preparation and support systems.

• TSBT02: Disassemble, Fault Find and Reassemble: Teaches how to inspect assemblies, identify faults, safely dismantle and reassemble components.

• TSBT03: Cone and Thread Installation: Covers assembly using cone and thread fittings, typically used in high-pressure systems.

• TSBT04: Pressure Testing: Involves pressure testing of SBT systems using hand pumps, air-driven pumps and pneumatic test methods.

Is there an assessment?
Each section has an assessment with and 80% pass rate and two attempts.